Publicité
English
Technical Information
Recommended water pressure
Max. water pressure
Recommended hot water temp.
Max. hot water temp
Flow rate - 16555xx1
handshower
spout @ 44 PSI
Flow rate - 16550xx1
handshower
spout @ 44 PSI
*Please know and follow all applicable local plumbing codes
when setting the temperature on the water heater.
Installation Considerations
• For best results, Hansgrohe recommends that this
unit be installed by a licensed, professional plumber.
• Please read over these instructions thoroughly
before beginning installation. Make sure that you
have all tools and supplies needed to complete the
installation.
This trim is for use with rough valve
13444181 (not included). The mounting surface
must be finished and made watertight before
installation of this trim kit.
• This unit is not anti-scald. In Massachusetts, or
if required by local plumbing code, install an
approved remote pressure balance valve or other
approved anti-scald device.
• Protection against backflow is provided by a
check valve in the handshower hose and by an
automatically resetting diverter.
2
15 - 75 PSI
145 PSI
120° - 140° F*
176°F*
1.8 GPM (6.8 L/min) max.
6.6 GPM (25 L/min)
2.0 GPM (7.6 L/min) max.
6.6 GPM (25 L/min)
• 16555xx1 only: This handshower is for use with
automatic compensating valves rated at 1.4 GPM
(5.3 L/min) or less.
• 16550xx1 only: This handshower is for use with
automatic compensating valves rated at 1.5 GPM
(5.7 L/min) or less.
• To prevent scald injury, the maximum output
temperature of the shower mixing valve must be no
higher than 120°F. In Massachusetts, the maximum
output temperature can be no higher than 112° F.
• Keep this booklet and the receipt (or other proof
of date and place of purchase) for this product in
a safe place. The receipt is required should it be
necessary to request warranty parts.
Publicité
