Velleman CS5MXP Notice D'emploi page 7

iii. Disc 2
This control is identical to Disc 1 and allows you to further identify the target signal being received.
With Disc 1 set at 5 to reject small iron and silver foil, commence searching. Remember the CS-5MXP is a
motion machine which means that the search head needs to be constantly sweeping, except when in pin
point mode.
You now need to set Disc 2 to ignore ring pulls.
Sweep the head above a ring pull and rotate Disc 2, at the same time depressing the Disc 2 push select
button with the thumb of the hand holding the machine. When the ring pull signal disappears this control is
set. Release the push button.
Your CS-5MXP automatically operates in Disc 1 so commence searching (see "Sweeping Technique".
When you receive a signal, this indicates that the target could be a silver hammered coin, ...
Depress the Disc 2 button and hold it in. Sweep the target object again. If you are still receiving a signal,
then it is likely to be any of the metal found above ring pulls ...
Disc 2 gives you greater analytical skills than a single discrimination machine but, even when Disc 2 does
not give a signal, still dig the target to avoid losing silver hammered etc.
CS5MXP
Effect of Discriminate Control Position
- 7 - VELLEMAN