Technaxx TX-186 Manuel D'utilisation page 20

B: Installing the new stylus
Hold the tip of the stylus head shell and insert it by
pressing in the direction illustrated by "B". Push the
stylus head shell upwards in the direction illustrated by
"C" until the stylus locks into the tip position.
(1) Guide pins inside
Caution
 Do not bend the stylus.  Do not touch the needle to avoid injury.  Turn
off the unit's power before you replace the stylus.  Keep out of reach of
children.  Handle with care as the stylus is delicate. Use of a bent or
broken stylus may damage the record and cause malfunction.  Do not
expose the stylus to extreme heat.
Bluetooth mode
Bluetooth playing
Turn on the device by turn the volume knob (12) until the indicator flashes
blue. Then you should turn on your phone or other media device and start
the Bluetooth searching function, receive carrier will receive the Bluetooth
identification number for: "Technaxx TX-186", when your Bluetooth device
is connected, the speaker will beep.
NOTE: Unplug an AUX-IN or Headphone before use the Bluetooth
function. Put the Tone Arm on tone arm rest and security latch. Control the
music from your playback device which is connected to the LP Player.
ATTENTION: If you reboot the machine, you should repeat those steps to
get the Bluetooth function restarted. The last connected device connects
automatically.
7
TX-186, 5000, 09/22