Technaxx TX-186 Manuel D'utilisation page 16

Before usage
 Choose the installation location of your unit carefully. Avoid placing it in direct
sunlight or close to a source of heat. Also avoid locations subject to vibrations and
excessive dust, heat, cold or moisture.  Do not install the unit in a inclined position,
It is designed to be operated in a horizontal position only.  If the unit is brought
directly from a cold to a warm location, moisture may condense inside the player, and
cause damage. When you first install the unit, or when you move it from a cold to a
warm location, wait for 30 minutes before operating the unit.  The ventilation holes
should not be covered. Make sure there is enough space above and beside the
amplifier/receiver.  Do not place a CD player or other equipment on top of the device.
 Do not open the cabinet. This might cause a damage to circuitry or electrical shock.
 If you are not going to use the player for long time, be sure to disconnect the player
from the AC power source. When removing the power plug, never yank the cord. 
To prevent fire or shock hazard, disconnect your unit from the AC-power source when
cleaning. Use caution when cleaning and wiping the plastic parts. Do not attempt to
clean the unit with the chemical solvents as this might damage the finish.
Technical specifications
Bluetooth
Bluetooth transmitting frequency 2.4GHz
Radiated output power max. 2.5mW
Mode
Speakers
Phono
AUX-IN & Headphone
RCA output
Power adapter voltage
Power input
Power consumption
Weight / Dimensions
Package contents
V5.0; range ~10m open areas
Phono, Bluetooth, AUX-IN, USB
2x 3W stereo loudspeakers,
impedance 4Ω, frequency range 75Hz–20kHz
EP/LP/SP; DC motor; speeds: 33/45/78rpm;
S/N≧45dB; needle cartridge (Model-ID:4768); belt-drive
3.5mm jack
Cinch (Left & Right)
100-240V 50/60Hz
DC 5V 1A
Max. 5W
2.2 kg / (L) 33.0 x (W) 28.5 x (H) 12.4cm
Bluetooth Retro LP-Player TX-186, 45rpm
single puck adapter, power adapter, user
manual
TX-186, 5000, 09/22
3