Technaxx TX-186 Manuel D'utilisation page 19

 Place a record on the turntable platter and select the correct player
speed: 33/45/78rpm according to the vinyl being played. When playing a
45rpm record, use the included 45rpm adaptor.
 Remove the stylus guard and unlock the tone arm lock.
 Push the lift lever up to raise the tone arm and then gently move the tone
arm to the desired position over the record.
The platter will begin to spin when the tone arm is moved toward the record.
Push the cue-lever (2) forward to lower the tone arm slowly onto the desired
position on the record. The record will begin playing.
 When the record is finished, push the tone arm lifter (2) backwards to
raise the tone arm and gently move it back to its rest position.
 When you have finished playing records, engage the tone arm lock to
protect it from accidental movement. Unplug the TX-186 from the power
supply if it is not going to be used for a while.
Replacing the Stylus
It is recommended that the stylus is replaced as soon as you notice a
change in the sound quality. Prolonged use of a worn-out stylus may
damage the record. Wear and tear on the stylus will be accelerated when
playing 78 RPM records.
A: Removing the stylus from the cartridge
Place a screwdriver at the tip of the stylus head shell and
push downwards in the direction shown in sketch "A".
Remove the stylus head shell by pulling it forwards and
pushing downwards.
1. Tone Arm / 2. Tone Arm Lifter
TX-186, 5000, 09/22
6