Publicité
Les langues disponibles
Les langues disponibles
WARNING
When you use the emergency starting
procedure, the start-in-gear protection
system will not work. If the shift lever is
not in the "NEUTRAL" position, the boat
can start off unexpectedly when the
engine is started, throwing occupants or
causing an accident.
Make sure that the shift lever is in the
"NEUTRAL" position before attempting to
start the motor using the emergency
starting procedure.
2. Remove the motor cover by moving the lock
lever in the direction of the arrow and lifting
the cover off.
36
3. Loosen the lock nut 1, take off the NSI
cable from the bracket and separate the end
of cable from the cam 2.
4. Remove the four bolts securing the recoil
starter assembly in place.
Lift off the recoil starter assembly.
5. Tie a knot in one end of the emergency
starter rope located in the tool kit. Tie the
other end around the screw-driver handle in
the tool kit.
6. Hook the knotted end of the rope in the pul-
ley notch and wind the rope around the pul-
ley in a clockwise direction.
7. Put the emergency stop switch lock plate in
place.
8. Remote control model:
Turn the ignition key to the "ON" position.
9. After following steps for normal starting pro-
cedure, pull the emergency starter rope
sharply to start the engine.
Publicité
