Télécharger Imprimer la page

AEG FSE83800P Notice D'utilisation page 41

Masquer les pouces Voir aussi pour FSE83800P:

Publicité

Les langues disponibles

Les langues disponibles

returns to its basic position on the
lower level.
There are two ways of lowering the
basket depending on the loading:
• If there is a full load of plates
slightly push the basket down.
• If the basket is empty or half-
loaded press the basket down.
9.2 Using the detergent
A
B
C
CAUTION!
Only use detergent
specifically designed for
dishwashers.
1. Press the release button (A) to open
the lid (C).
2. Put the detergent, in powder or
tablets, in the compartment (B).
3. If the programme has a prewash
phase, put a small quantity of
detergent on the inner part of the
appliance door.
4. Close the lid. Make sure that the lid
locks into position.
9.3 Setting and starting a
programme
The Auto Off function
This function decreases energy
consumption by deactivating
automatically the appliance when it is not
operating.
The function comes into operation:
• 5 minutes after the completion of the
programme.
• After 5 minutes if the programme has
not started.
Starting a programme
1. Press the on/off button to activate
the appliance. Make sure that the
appliance is in programme selection
mode and the door is closed.
2. Press Program again and again until
the indicator of the desired
programme is on.
The display shows the programme
duration.
3. Set the applicable options.
4. Press Start to start the programme.
• The indicator of the running
phase is on.
• The programme duration starts to
decrease with steps of 1 minute.
Starting a programme with
delay start
1. Set a programme.
2. Press Delay again and again until the
display shows the desired delay time
(from 1 to 24 hours).
3. Press Start to start the countdown.
• The delay indicator comes on to
confirm the start of the
countdown.
• The countdown starts to decrease
with steps of 1 hour. Only the last
hour decreases with steps of 1
minute.
When the countdown is completed, the
programme starts and the indicator of
the running phase comes on. The delay
indicator is off.
Opening the door while the
appliance operates
Opening the door while a programme is
running stops the appliance. It may affect
the energy consumption and the
programme duration. After closing the
door, the appliance continues from the
point of interruption.
If the door is opened for
more than 30 seconds
during the drying phase, the
running programme ends. It
does not happen if the door
is opened by AirDry
function.
ENGLISH
41

Publicité

loading