Publicité
Les langues disponibles
Les langues disponibles
36
www.aeg.com
• The indicator
• The display shows the current
setting: e.g.
2. Press
setting.
3. Press on/off to confirm the setting.
6.3 The rinse aid empty
notification
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
When rinse aid chamber is empty, the
rinse aid indicator is turned on notifying
to refill rinse aid. If the drying results are
satisfactory while using multi-tablets
only, it is possible to deactivate the
notification for refilling rinse aid.
However, for best drying performance,
always use rinse aid.
If standard detergent or multi-tablets
without rinse aid are used, activate the
notification to keep the rinse aid refill
indicator active.
How to deactivate the rinse
aid empty notification
Make sure the appliance is in user mode.
1. Press
• The indicators
and
• The indicator
• The display shows the current
setting.
–
–
2. Press
3. Press on/off to confirm the setting.
6.4 The rinse aid dispenser
The rinse aid helps to dry the dishes
without streaks and stains.
The rinse aid is automatically released
during the hot rinse phase.
still flashes.
= level 5.
repeatedly to change the
.
,
,
are off.
still flashes.
= the rinse aid empty
notification is deactivated.
= the rinse aid empty
notification is activated.
to change the setting.
It is possible to set the released quantity
of rinse aid between level 1 (minimum
quantity) and level 6 (maximum quantity).
Level 0 deactivates the rinse aid
dispenser and no rinse aid is released.
Factory setting: level 4.
How to set the rinse aid level
Make sure the appliance is in user mode.
1. Press
• The indicators
and
• The indicator
flash.
• The display shows the current
setting: e.g.
2. Press
setting.
3. Press on/off to confirm the setting.
6.5 Acoustic signals
Acoustic signals sound when a
malfunction of the appliance occurs. It is
not possible to deactivate these acoustic
signals.
There is also an acoustic signal that
sounds when the programme is
completed. By default this acoustic
,
signal is deactivated but it is possible to
activate it.
How to activate the acoustic
signal for the end of
programme
Make sure the appliance is in user mode.
1. Press
• The indicators
and
• The indicator
• The display shows the current
setting.
.
,
are off.
continues to
= level 4.
– The levels of rinse aid range
from 0A to 6A where level 0A
means rinse aid is not used.
repeatedly to change the
.
,
are off.
still flashes.
–
= the acoustic signal is
deactivated.
,
,
,
,
Publicité
