Thane Bike Nook Instructions De Montage page 13

Step 4
Set the Adjustment Arms & Support Bars
To support the sides of the fender or rack of your bicycle when stored on the
Bike Nook™ Pro, the Adjustment Arms can be set with the Support Bars at
various distances apart - from narrow to wide (see Fig. 5 – 7).
FIG. 5
If your bicycle is fitted with just a fender, measure the width of the fender. If it
is fitted with just a rack or a rack and a fender, measure the width accordingly.
With the Long Bolt only lightly tightened, set the Support Bars at the desired
distance apart by rotating the Adjustment Arms so that the distance between
the two Supporting Bars is slightly wider than the width of the fender or the rack.
Note: When rotating the Adjustment Arms, ensure that the Adjustment Arms
are set at the same angle and symmetrical to one another.
Once set to the desired width, measure the height of the Support Bars above
the Track. This should be approximately half the diameter of the wheel of your
bicycle. At this height, the Support Bars can effectively support the sides of
the fender or the rack when your bicycle is stored. If not, unscrew the Long
Bolt and the Short Bolt and reposition the Connector Plate to be lower or
higher on the Upright to achieve the desired height of the Support Bars.
Securely tighten and lock the Long Bolt to ensure that the Adjustment Arms
remain in the set position (see Fig. 7 above). Also tighten the Short Bolt.
All manuals and user guides at all-guidesbox.com
FIG. 6
11
Tighten
& lock
FIG. 7