Thane Bike Nook Instructions De Montage page 12

Step 2
Assemble the Adjustment Arms & Connector Plate
Overlap the holes in the Adjustment Arms – one in front of the other, with the
Support Bars facing in the same direction and away from you (see Fig 2).
Place the Connector Plate behind the overlapping Adjustment Arms - and on
the same side of the Adjustment Arms where the Support Bars are connected.
Align the overlapping holes of the Adjustment Arms with one of the holes in
the Connector Plate.
Insert the Long Bolt through a Washer and the two holes in the Adjustment
Arms, and through the one (top) hole in the Connector Plate. Insert the Short
Bolt through the (bottom) hole in the connector plate.
FIG. 2
Step 3
Attach the Connector Plate to the Upright
Attach the Connector Plate to the Upright by inserting the Long Bolt through
one of the holes in the Upright, for example, through the 6th hole from the
top of the Upright (see Fig. 3) or an alternative hole depending on the size of
your bicycle.
All manuals and user guides at all-guidesbox.com
Long Bolt
Short Bolt
FIG. 3
10
Long Bolt
Short Bolt
FIG. 4