Publicité
Les langues disponibles
Les langues disponibles
Bike Nook™ Pro Kit
Assembly & Use Instructions
The Bike Nook™ Pro Kit is an attachment that connects to the Upright of the
Bike Nook™ Pro to accommodate and store bicycles fitted with back racks
and/or fenders (mud guards). For these bicycles it may be difficult to engage
the back wheel of the bicycle with the Upright. By installing the Pro Kit, bicycles
with fenders or mudguards can now be stored with added stability.
The Bike Nook™ Pro Kit also accommodates fat tire bikes that cannot be
secured with the regular Bike Nook™ unit. The track of the regular Bike Nook™
unit can accommodate fat tires up to 3.9in/10cm wide. For bikes with even
wider fat tires, up to 5in/13cm, it is recommended to install the Bike Nook™
Pro Kit for proper support.
Parts & Alignment
1.
Adjustment Arm x2
2. Support Bar x2
3. Connector Plate x1
4. Washer x5
5. Long Bolt x1
6. Short Bolt x1
7.
Nut x4
8. Sleeve x4
Note:
Socket Wrench x1 (this comes with the Bike Nook™ main unit unless the Pro
Kit is ordered on its own)
Allen Key x1 (this comes with the Bike Nook™ main unit unless the Pro Kit is
ordered on its own)
Step 1
Connect the Support Bars to the
Connect the Support Bars by inserting
them into the slotted ends of the
Adjustment Arms, using 2x Washers,
2x Nuts and the Socket Wrench (see Fig. 1)
All manuals and user guides at all-guidesbox.com
Upgrade (Optional)
2
8
9
2
4
7
1
1
7
4
4
7
4
5
3
FIG. 1
Slotted End
Hole End
4 7
6
Publicité
