T.I.P. HWW 1300/25 Plus TLS F Mode D'emploi page 13

Please inspect the device for damage occurred during transportation. In case of damage, the retailer has to be
informed immediately, at the latest within 8 days after the date of purchase.
2. Range of use
Booster sets from T.I.P. are self-priming electrical pumps with a mechanical or electronic pump control system for
automated operation. These high-quality products with their convincing performance data were developed for the
various purposes involved with irrigation, domestic water supply and pressure boosting, as well as for discharging
water at a constant pressure. The devices are suitable for pumping clean, clear water.
The typical areas of use of booster sets include: Automatic domestic water supply with grey water from wells and
cisterns, automated irrigation of gardens and garden beds and sprinkling, pressure boosting within the domestic
water supply system.
The device is not suited for use in swimming pools.
This product was developed for private use, i.e. not for industrial applications or for continuous operation.
The pump is not suited to discharge saltwater, faeces, inflammable, etching, explosive or
other hazardous liquids. Please observe the max. and min. temperatures of the liquids to be
discharged stated in the technical data.
3. Technical Data
Model
Mains voltage / frequency
Nominal performance
Protection type
Suction port
Pressure port
1)
Max. flow rate (Q )
max
Max. pressure
1)3)
Max. delivery height (H )
max
Max. suction height
Volume of the pressure tank
Max. size of the solids being pumped
Max. permissible operating pressure
Min. ambient temperature
Max. ambient temperature
Min. fluid temperature
Max. fluid temperature (T )
max
Max. cut-in frequency in one hour
Length of connection cable
Cable type
Weight (net)
Guaranteed sound power level (L
Measured sound power level (L
2)
Sound pressure level (L )
pA
Dimensions (L x D x H)
Item no.
1)
The values were determined with free, unreduced in- an outlet.
2)
Noise emission values obtained according to the EN 12639 regulation. Measurement method according to EN ISO 3744.
3)
Due to the factory pre-set switch off pressure of the pressure switch, pressure is limited to approx. 3 bar (30 m delivery
head). The theoretically achievable pressure of the pump unit of the domestic water supply can reach the value specified
under "Max pressure". Consult a qualified specialist, to adapt the pressure circuit to your requirements if necessary, see
also the chapter "Setting the pressure switch".
4. Scope of delivery
The scope of the delivery of this product includes:
One booster set with a connection cord, one G 7 pre-filter, one double nipple, Teflon tape, one separate leaflet
regarding the installation of the filter, one operating manual.
HWW 1300/25 Plus TLS F
230 V~ / 50 Hz
1,200 Watt
IPX4
30.93 mm (1 "), female
30.93 mm (1 "), female
4,350 l/h
5.0 bar
50 m
9 m
22 l
3 mm
6 bar
5 °C
40 °C
2 °C
35 °C
40, evenly distributed
1.5 m
H07RN-F
15.2 kg
2)
86 dB
)
WA
2)
84.5 dB
)
WA
78.9 dB
53 x 26 x 51 cm
31157
HWW INOX 1300 Plus F
230 V~ / 50 Hz
1,200 Watt
IPX4
30.93 mm (1 "), female
30.93 mm (1 "), female
4,350 l/h
5.0 bar
50 m
9 m
22 l
3 mm
6 bar
5 °C
40 °C
2 °C
35 °C
40, evenly distributed
1.5 m
H07RN-F
15.2 kg
86 dB
84.5 dB
78.9 dB
53 x 26 x 59 cm
31155
2
10