Kuppersbusch FKGF8800.0i Mode D'emploi page 34

34
Problem
The compressor does not
start immediately after
pressing the "FastFreeze" or
"Shopping", or after chang‐
ing the temperature.
Water flows inside the refrig‐
erator.
Temperature cannot be set.
dEMo appears on the dis‐
play.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The "FastFreeze function"
or "Shopping function" is
switched on.
This is normal, no error
has occurred.
Food products prevent the
water to flow into the wa‐
ter collector.
The "FastFreeze function"
or "Shopping function" is
switched on.
The appliance is in dem‐
onstration mode.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
The food products' tem‐
perature is too high.
Many food products are
stored at the same time.
Solution
Wait few hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor‐
ing.
Refer to "Closing the door".
Refer to "FastFreeze function"
or "Shopping function".
The compressor starts after a
period of time.
Make sure that food products
do not touch the rear plate.
Switch off "FastFreeze func‐
tion" or "Shopping function"
manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function" or
"Shopping function".
Keep the OK pressed for ap‐
proximately 10 seconds until a
long sound is heard and dis‐
play shuts off for a short time.
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".
Let the food products temper‐
ature decrease to room tem‐
perature before storage.
Add less food products at the
same time.