Publicité
Les langues disponibles
Les langues disponibles
Note: For natural stone worktops, adhere the
mounting rails with temperature-resistant duel-
component adhesive (metal on stone).
2
For combination with the VD 201 device cover:
Mount device cover to device prior to installation
(see VD 201 Installation Instructions).
3
Insert device in cut-out. The latching lugs on the
device must lie precisely on the clamp springs.
Press device firmly into the cut-out.
lugs on the device must snap into the clamp
springs.
Connect Gas Supply
The appliance is shipped from the factory for use with
natural gas. It must be converted for use with propane.
A qualified technician or installer must do the
conversion.
Before connecting the appliance, please check whether
the local connection conditions such as gas type and
gas pressure match the appliance settings.
Make sure the gas supply is turned off at the manual
shut-off valve before connecting the appliance.
The gas connection must be in a location that permits
access to the manual shut-off valve and which, if
applicable, is visible after opening the door of the
cabinet.
SERVICER INFO ONLY
Connect the gas supply using the ½" U.S.A. elbow and
the fiber gasket supplied with the unit. The shorter,
nontapered thread fits into the threaded nut on the hob.
The longer, tapered U.S.A. thread is for the incoming
gas supply. Vent the gas line, check for leaks. The gas
pressure regulator is supplied with the unit and comes
set for natural gas. To convert regulator to LP (propane)
gas:
Make-Essex Model SX 229 NA-602 ½ PSIG
1
2
3
Make-Maxitrol Model RV 47 CL ½ PSIG
1
2
3
The latching
4
Connect Electrical Supply
Before connecting supply cord to wall receptacle, make
certain that gas shutoff valve and all burner controls are
in OFF position.
Electrical connection (AC 110-127 V) is established by
means of a connecting cord with a grounding contact
plug connected to a grounded socket, which must also
be accessible after installation of the gas cooktop.
Burner Cap Placement
The burner parts must be properly placed for the
cooktop to function properly. If the burner parts are not
properly placed, one or more of the following problems
may occur:
▯
▯
▯
▯
▯
Placing Burner Parts
After electrical connection is complete, assemble the
burner parts correctly and evenly. When assembling the
burner parts, make sure that the burner head is placed
on the base in such a way that the heat sensor is
positioned in the opening on the burner head. The
catching pin on the burner ring must fit in the
corresponding groove on the burner head
Remove the aluminum cap from the top of the
regulator.
Turn the cap over. It will have LP 10 stamped inside.
Replace the cap on the regulator.
Remove the aluminum cap from the top of the
regulator.
Remove the yellow plastic shaft from the cap by
pushing it sideways until it pops out of the groove in
the cap.
Turn the shaft over and push back into the cutout in
the cap.
Replace the cap on the regulator.
Burner flames are too high.
Flames shoot out of burners.
Burners do not ignite.
Burner flames light unevenly.
Burner emits gas odor.
9
Publicité
