Publicité
Les langues disponibles
Les langues disponibles
PREPARATION
PREPARATION:
Verify you have all parts before beginning the
installation. Check foam insert closely for missing
parts. Remove motor from packing. To avoid
damage to finish, assemble motor on soft padded
surface or use the original foam inset in motor box.
DO NOT LAY MOTOR HOUSING ON ITS SIDE AS
THIS COULD RESULT IN SHIFTING OF MOTOR
IN DECORATIVE ENCLOSURE.
INSTALLING THE HANGING BRACKET
CAUTION: To avoid possible electrical shock, be sure electricity is
turned off at the main power box before wiring. All wiring must be
in accordance with National and Local Electrical Codes and the
ceiling fan must be grounded as a precaution against possible
electric shock.
Locate ceiling joist where fan is to be mounted, being sure
1
location agrees with the requirements in the minimum
clearance section of this guide. Wood joists must be sound
and of adequate size to support 35 pounds (See page 2,
items 3 and 4).
2
If not already present, mount a UL listed outlet box marked
"suitable for fan support" following the instructions provided
with the outlet box. The outlet box must be able to support
a minimum of 35 pounds.
Attach hanging bracket to outlet box using screws provided
3
with the outlet box.
Canopy
Downrod
Blade
Parts identification on assembled fan.
Ceiling fan
outlet box
Hanger
bracket
Flat washer
Spring washer
Outlet box screw
Fig. 1
Yoke cover
Motor Housing
LED Light Kit
©2021 Hinkley Lighting, Inc. | hinkley.com |
05
Publicité
