Hinkley MERRICK 60 Manuel D'instructions page 11

FINISHING THE INSTALLATION
1 Tuck connections neatly into ceiling outlet box.
Slide the canopy up to the mounting bracket and place
2
one of the key hole slots over the mounting screw on the
mounting bracket. Rotate the canopy until the screw head
locks in place at the narrow section of the key hole.
Align the circular hole on canopy with the remaining hole
3
on the mounting bracket, secure by tightening the two set
screws.
Attach the trim ring to the canopy screws heads on the
4
bottom of the canopy by inserting the screw heads into
the key slots in the trim ring and rotating it clockwise.
NOTE: Adjust the canopy screws as necessary until the
canopy and trim ring are snug.
Make sure the hook on the hanging bracket properly sits in the groove in the hanger ball before
attaching the canopy to the bracket by turning the housing until it drops into place.
Ceiling Fan
Outlet Box
Hanger
Bracket
Canopy
Trim Ring
Fig. 1
WARNING:
Groove
Screws
©2021 Hinkley Lighting, Inc. | hinkley.com | 09