Hinkley MERRICK 60 Manuel D'instructions page 10

ELECTRICAL CONNECTIONS
REMEMBER -Turn off the power! NOTE - Control must be installed
within 30 feet of fan.
WARNINGS: Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire nuts, except for
the ground wire.
CAUTION: To reduce the risk of electric shock, this fan must be
installed with an isolating wall control/switch.
1. Insert the receiver into the ceiling mounting bracket with the flat
side of the receiver facing the ceiling. (Fig. 1) For best performance,
make sure the Black Antenna and WIFI Antenna, on the end of
the receiver, remains extended and not tangled with any of the
electrical wires.
2. Make wire connections from the fan to the receiver unit. For this
step use the bundle of 5 wires on the receiver. (Fig. 2)
Connect the YELLOW fan wire to the YELLOW receiver wire.
Connect the GRAY fan wire to the GRAY receiver wire.
Connect the RED fan neutral wire to the RED receiver neutral wire.
Connect the WHITE fan neutral wire to the WHITE receiver neutral
wire.
Connect the BLUE fan neutral wire to the BLUE receiver neutral wire.
3. Connect the wiring from the ceiling to the receiver unit. (Use the
2 wire bundle on the receiver.) Secure with supplied wire nuts.
Connect the BLACK building supply wire to the BLACK receiver
wire.
Connect the WHITE receiver neutral wire to the WHITE building
neutral wire.
Connect the COPPER building ground wire to the 4 YELLOW/
GREEN ground wires from the fan and receiver.
Receiver
Fig. 1
08 |
hinkley.com
BLK (AC IN)
WH (AC IN)
BLUE (For light)
WHITE
(For light)
Receiver
Hanger
bracket Fig. 2
GROUND
GRAY
YELLOW
RED
RED
YELLOW
GRAY
Fan
Outlet box
Ceiling