Hinkley MERRICK 60 Manuel D'instructions page 13

Les langues disponibles

INSTALLING THE LED ASSEMBLY AND GLASS SHADE

NOTE: Be sure the power is off before installing.

Remove one of the three screws on the adapter plate located

on the fan motor. Loosen the other 2 screws. (Do not remove)

(Fig. 2)

While holding the LED assembly under your fan, make the

polarized plug connections: (Fig. 2)

- Red to white

- Black to black

Tuck connections neatly into adapter plate. Place the key

holes on the LED assembly over the 2 screws previously

loosened, turn the LED assembly until it locks in place at the

narrow section of the key holes. Secure by tightening the 2

screws previously loosened and the one previously removed.

Raise the glass shade against the LED assembly and turn

clockwise until snug, DO NOT OVERTIGHTEN.

Restore power and your LED assembly is ready for operation.

Wire connectors

LED

assembly

Glass shade

Fig. 2

Screws