Hinkley MERRICK 60 Manuel D'instructions page 16

Option 3. Multi Gang Wall Switch Box Installation
1
Remove the existing wall plate and old switch from the wall outlet box. (Fig. 3)
2 Connect the black lead wires from the switch in the cradle A to the black wires in the switch box. Hot input wire to one of the cradle
switch leads. Power lead to the fan is connected to the remaining switch lead. (Fig. 4)
3
Attach the cradle A to the wall switch box using the supplied hardware.
Attach the multi-gang faceplate to the switch set in the wall outlet box. Cradle A of Hinkley switch will fit in any standard decora
4
face plate.
5 Remote transmitter will be held in place with built in magnets.
Outlet box
Switch
Fig. 3
HIRO Control System
14 | hinkley.com
Outlet box
Face plate
Fig. 4
Cradle A
Face plate
Transmitter