Bosch GOP 14,4 V-EC Professional Notice Originale page 17

All manuals and user guides at all-guides.com
OBJ_BUCH-1808-002.book Page 17 Tuesday, April 7, 2015 4:33 PM
Accessory
Scraper, flexible* Silicone and other
Base plate for
sanding, series
Delta 93 mm*
* Optional accessory; for the complete accessories please see Bosch ac-
cessory programme.
Mounting/Replacing the Application Tool/Accessory
If required, remove an already mounted application tool/ac-
cessory.
For this, open the SDS lever 8 to the stop (not further) and re-
move the application tool.
Mount the requested application tool/accessory (e.g. plunge
cut saw blade 11) in such a manner on the tool holder 9 that
the offset faces downward (see illustration on the graphics
page; marking on the application tool/accessory is readable
from above).
Turn the application tool/accessory to a position favourable
for the respective job, and allow it to engage into the cams of
the tool holder 9. 12 different positions are possible, each
offset by 30°.
Selecting the Sanding Sheet
Depending on the material to be worked and the required rate of material removal, different sanding sheets are available:
Sanding disc Material
– All wooden materials
(e. g., hardwood, soft-
wood, chipboard, build-
ing board)
– Metal materials
– Paint
– Varnish
– Filling compound
– Filler
Bosch Power Tools
Close SDS lever 8 so that it faces against the housing of the
Material
power tool.
 Check the tight seating of the application tool/accesso-
elastic materials
ry. Incorrect or not securely fastened application tools/
accessories can come loose during operation and pose a
hazard.
Depends on sanding
Mounting/Replacing a Sanding Sheet on the Sanding
sheet
Plate
The sanding plate 12 is fitted with Velcro backing for quick
and easy fastening of sanding sheets with Velcro adhesion.
Before attaching the sanding sheet 13, free the Velcro back-
ing of the sanding plate 12 from any debris by tapping against
it in order to enable optimum adhesion.
Position the sanding sheet 13 flush alongside one edge of the
sanding plate 12, then lay the sanding sheet onto the sanding
plate and press firmly.
To ensure optimum dust extraction, pay attention that the
punched holes in the sanding sheet match with the holes in
the sanding plate.
To remove the sanding sheet 13, grasp it at one of the tips and
pull it off from the sanding plate 12.
You can use all sanding sheets, fleece pads/polishing cloth
pads of the Delta 93 mm series of Bosch accessory program.
Sanding accessories, such as fleece pads/polishing cloth
pads, are attached to the sanding plate in the same manner.
Application
For coarse-sanding, e. g. of rough, unplaned beams and
boards
For face sanding and planing small irregularities
For finish and fine sanding of wood
For sanding off paint
For sanding primer (e. g., for removing brush dashes,
drops of paint and paint run)
For final sanding of primers before coating
English | 17
Grain size
coarse 40
60
medium 80
100
120
fine 180
240
320
400
coarse 40
60
medium 80
100
120
fine 180
240
320
400
1 609 92A 117 | (7.4.15)