Beko GNE 134605 E Mode D'emploi page 9

3 Installation
C
Please remember that the manufacturer
shall not be held liable if the information
given in the instruction manual is not
observed.
Points to be considered
when re-transporting your
refrigerator
1. Your refrigerator must be emptied and
cleaned prior to any transportation.
2. Shelves, accessories, crisper and etc.
in your refrigerator must be fastened
securely by adhesive tape against any
jolt before repackaging.
3. Packaging must be tied with thick
tapes and strong ropes and the rules of
transportation printed on the package
must be followed.
C
Always remember...
Every recycled material is an
indispensable source for the nature and
for our national resources.
If you wish to contribute to recycling the
packaging materials, you can get further
information from the environmental
bodies or local authorities.
Before operating your
refrigerator
Before starting to use your refrigerator
check the following:
1. Is the interior of the refrigerator dry and
can the air circulate freely in the rear of
it?
2. Insert the 2 plastic wedges onto the
rear ventilation cover as illustrated in
the following figure. To do this, remove
the screws on the product and use the
screws given in the same pouch.
Plastic wedges will provide the required
distance between your refrigerator
and the wall in order to allow the air
circulation.
All manuals and user guides at all-guides.com
3. Clean the interior of the refrigerator as
4. Plug the refrigerator into the wall outlet.
5. You will hear a noise as the compressor
6. Front edges of the refrigerator may
Electric connection
Connect your refrigerator to a grounded
Important:
B
B
8
EN
recommended in the "Maintenance and
cleaning" section.
When the door is open the respective
interior light will come on.
starts up. The liquid and gases sealed
within the refrigeration system may
also give rise to noise, even if the
compressor is not running and this is
quite normal.
feel warm. This is normal. These areas
are designed to be warm to avoid
condensation.
socket which is being protected by a
fuse with the appropriate capacity.
The connection must be in compliance
with national regulations.
The power cable plug must be easily
accessible after installation.