Publicité
6.
ELEMENTS DE FONCTIONNEMENT
6
7
8
9 10 11
12
13 14
1.
Col de cygne
2.
DEL de la pile
3.
DEL d'alimentation
4.
Ecran
5.
Compartiment pour pile
6.
Connexion microUSB
7.
Bouton MENU
32
1
2
3
4
5
8.
Bouton ↓
9.
Bouton de relâche
10.
Bouton ↑
11.
Bouton marche/arrêt
12.
Connexion miniUSB
13.
Fente microSD
14.
Sortie vidéo
7.
INSERTING / REPLACING BATTERIES
1.
Loosen the screw using a Phillips screwdriver and take off the cover of the battery compartment.
2.
Remove the battery holder from the battery compartment.
3.
Insert four AA batteries into the battery holder, observing the polarity markings inside the battery
holder bays.
4.
Put the battery holder back into the battery compartment, observing the polarity markings on the
top of the battery holder and inside the battery compartment.
5.
Close the battery compartment again.
Replace the batteries when the battery LED is on.
8.
CONNECTING CAMERA
1.
Connect the plug of the gooseneck camera to the socket on the base unit. The protruding metal
tongue on the camera's plug should be facing the recess on the front side of the socket.
2.
Slide the screw cap upwards, toward the camera and screw the screw cap counter-clockwise to
fasten the camera.
3.
Follow these steps in reverse order when disconnecting the camera from the base unit.
9.
INSERTING microSD CARD
To use the photo/video function, you fi rst have to insert a microSD card (not included in delivery). For
this, proceed as follows:
1.
Open the cover on the right side of the display.
2.
Insert a microSD card into the microSD slot. The contacts of the card have to face toward the
display. The card has to snap into place.
3.
Close the cover again.
10.
BASIC FUNCTIONS
Only immerse the camera head and camera neck in liquids that are voltage free!
The camera neck is not to be submerged further than the marking "MAX Water
Level".
The endoscope may only be used for inspection of dead systems. The camera head
is made of metal and can lead to short circuits. For safety reasons, disconnect all
system parts from the power supply before every inspection.
Avoid strong mechanical strains or vibrations. Make sure you never go below the
minimum bending radius of 45 mm.
21
Publicité
Chapitres
