Samsung RF22KREDBSR/AA Guide D'utilisation page 29

• Tilt up the front of the drawer and pull straight
out, and pull out the drawer after moving
slightly in the direction of the arrow.
To re-install
• Insert the drawer into the frame rails and push
back into place.
• Slide bin in above the desired location and
push down until it stops.
The drawers need to be removed before
the glass shelf above them can be lifted
CAUTION
out.
5. Flex Zone
To remove the Flex Zone – Pull the Flex door
out to full extension. Lift the Flex Zone up, pulling
it to your body with both hands.
To re-install the Flex Zone – Open the Flex door
to full extension. Tilt the front of the Flex Zone up,
place the back of the Flex Zone onto the rails, and
then lower the front until the whole Zone rests on
the rails.
To remove the divider and the metal cooling
plate from the Flex Zone
1. Slide the divider to the end as shown.
RF22KR_DA68-02897B-04_EN.indd 29
2. As the divider has the width and length bars,
push the lower part of each bar inward to
unlock. See the pictures for details.
3. Hold the divider and pull up to remove.
4. Turn over the drawer to remove the metal
cooling plate.
The Drawer and Metal cooling plate are
heavy.
CAUTION
It may cause a personal injury or material
damage.
To reinsert the metal cooling plate into the
Flex Zone along with the divider – Follow
the removal steps above in the reverse order to
reinsert the metal cooling plate.
Reinsert the divider into the Flex Zone firmly until
you hear a clicking sound.
English 29
2018-07-05 12:23:06