Steering Trim (St.trim); Throttle Trim (Th.trim) - GM Racing XG-6i Manuel D'utilisation

STEERING TRIM (ST.TRIM)

Steering neutral adjustments can be made by moving the steering trim knob to the left or the
right. The ST.DR-LED shows the trim position.
TURN LEFT
Racers-Tip: Always check and be sure the servo is at its neutral position before installing a
servo. Adjust the servo horn hole position and linkage so both are parallel. When a servo
saver is used place it as closer to center position as possible. Be sure the steering trim
on the transmitter at the neutral position. Trim Operation And Maximum Trav: Changing the
trim can effect the overall settings, when adjustments are made with the trims, please recheck
your installation for maximum servo travel (ST.D/R).

THROTTLE TRIM (TH.TRIM)

Throttle neutral adjustments can be made by moving the throttle trim to the left or the right.
The ST.DR-LED shows the trim position.
Racers-Tip: When using a electronic speed control, please set the throttle trim to neutral and
make adjustments to the speed control. On a gas powered model, set the trim to neutral and
adjust the linkage to the point where carburetor is fully closed in accordance with the engine
instruction manual. Trim Operation and Travel Trim adjustments will effect the overall ser-
vo travel, so please check the (back-ward) movement after the adjustment. When trim
movement is goes to extremes: That means if you make a lot of the trim movement to get the
servo to the neutral position, please recenter the servo horn closer to the neutral position and
inspect your throttle linkage.
94002 GM-Racing XG-6i 2.0 FHSS Sport Spec
Caution:
When fi nd the direc-
tion is wrong, you can
change it with the ser-
vo reverse switch!
1. When adjust the trim but-
ton, the ST.DR-LED appears
green fl ash.
2. When in the neutral positi-
on, the ST.DR-LED appears
red.
3. When in max. position, the
ST.DR-LED appears fl ashing
red, then all appears.
FLASH
FLASH
TURN RIGHT
18