Binding Process; Operating The Remote Control; Aux-Channel - GM Racing XG-6i Manuel D'utilisation

Be careful with the installation of the receiver. Never bend or shorten the coaxial
antenna wire! The actual „antenna" is the stripped end of the antenna wire and
must be installed in the vehicle so far above as possible. Avoid damages of the
antenna cable!

BINDING PROCESS

1. Turn on the transmitter. Then connect the power of receiver while keeping the Bind-Button
on top of the receiver pushed. The BIND-LED will fl ash red.
2. The biding is succesfull, when the BIND-LED turn into solid green. Now you can release the
Bind-button.
Bind-LED
Note:
1. During Frequency Pin Setup, make sure that Tx and Rx is one meter away, and around 10
meters there is no similar (2.4 GHz) device.
2. Once success, no need to process the Binding again for that receiver.
3. If fail in Setup (BIND-LED fl ashes red), please try again patiently.

OPERATING THE REMOTE CONTROL

•
Run your car never with low transmitter or receiver batteries.
If the Power-LED on the transmitter starts fl ashing, stop running your model
and change or recharge batteries!
• Never forget switch off the radio after running your vehicle , otherwise the batteries do not
last long.
• Turn on the transmitter fi rst, then the vehicle.
• After driving fi rst turn off the vehicle, then the transmitter.
• For optimal use fi rst check the steering and throttle trim positions.
AUX CHANNEL FUNCTION (CH3)
The AUX-Channel is designed purely as a control channel and is not adjustable. The connected
servo makes a movement of 90 °.
With the switch in position „AUX", the servo rotates clockwise, in „OFF" position counterclock-
wise.
15
Bind-Button
AUX-Switch
94002 GM-Racing XG-6i 2.0 FHSS Sport Spec
„AUX"
„OFF"