Husqvarna CTH 184T Manuel D'instructions page 23

TO ASSEMBLE BAGGER
• Unfold bag and stand right side up.
• Uninstall carriage bolts (5/16-18 x 1.5) and nuts (1) from the
front of the top frame.
1
• With bagger assembly on its side, feed front bagger frame
ends (2) through fabric loops at each side of bagger.
• Reinstall carriage bolts and nuts (1) to connect front frame
to top frame, passing through bagger fabric (4).Tighten
securely.
CAUTION: Do not exceed 100 In-Lbs/11,2 Nm.
• Snap front bagger frame bottom (3) into snap feature (5) at
front of bagger bottom.
4
1
• Remove cross braces (6) from inside of bagger assembly.
• Slide cross brace (6) onto pin (7) at the rear of the upper
bagger frame and secure with retainer spring clip (8).
• Secure cross brace (6) with clevis pin (9) at the front of the
bagger frame and secure with retainer spring clip (10).
• Repeat on opposite side.
8
9
10
6
TO INSTALL BAGGER SUPPORT ASSEMBLY
• Install carriage bolts (1) and locknuts (2) onto upper clevis
brackets (3) and bagger pivot assembly (4) as shown.
4
2
3
1
2
3 5
7
5
2
3
• Using two carriage bolts (5) and two nuts (6), secure the
left hand mid bracket (7) to the left hand front bracket (8) as
shown. Mid brackets should be on the outside of the front
brackets. Repeat on opposite side.
NOTE: Nominal position (9) is when edges of brackets are
aligned as shown.
5
• Connect the strut (10) to the left and right mid brackets using
two carriage bolts (11) on each side. Do not install nuts in
this step.
10
3
• Install the left bagger pivot (12) using one screw (13) and
one nut (14) as shown. Repeat on opposite side.
12
13
• Slide weldment (15) through hole in left pivot, then install the
right pivot (16) with one screw (17) and nut (18) as shown.
15
• Using one screw (19) and nut (20) install the actuator bracket
(21) as shown.
21
23
8
7
11
11
14
18
16
17
20
19
2
9
6