Publicité
Les langues disponibles
Les langues disponibles
Brief instructions – for rapid programming
If all of the following requirements are met, the device can be put into operation in the way
described below.
– Storage heater system with control voltage system 80 % ED
– Use of the supplied or an existing DIN atmospheric sensor
– Charging model is provided in the table on page 8–10.
Setting time
Button
LCD
P
00 : 00
00 : 00
Press
14:51
Setting charging model
Button
LCD
M
INST
Press for
approx.
3 sec.
P
LM
Press
LM
4x
M
14 : 53
14 : 53
Press
The controller now operates using all parameters for the specific charging model.
All manuals and user guides at all-guides.com
Button
Press
VR LF LZ KU
–
+
or
ED
SH
SYN
VR LF LZ KU
M
ED
SH
SYN
Button
VR LF LZ KU
ED
SH
SYN
Press
VR LF LZ KU
–
+
or
ED
1
SH
SYN
VR LF LZ KU
ED
28
SH
SYN
VR LF LZ KU
ED
SH
SYN
Note
This display appears when the device is put into
operation of the first time or following a power failure
which lasted longer than approx. 6 hours.
If the time is not set, the ELFAMATIC µC 3000
automatically operates as a forward controller.
Charging is performed in all cases.
The time is stored.
If no button is pressed after the time has been set, the
UHR (time) parameter remains active for 15 minutes (the
clock continues to run) and is stored automatically when
the 15 minutes have elapsed.
Note
Select the desired charging model from the „Charging
model" table (see page 8–10) and enter the code
number.
If no button is pressed for 15 minutes, the display
automatically returns to the default display (time and
outside temperature are shown alternately).
All necessary entries have now been made.
For the User
21
Publicité
