EIBENSTOCK ESM 1311 Set Notice Originale page 19

Attention!
High-energy and high-frequency interference can cause
!
fluctuations in speed. In case of low speed adjustments, the
machine can be overloaded easier.
Even if the electronics is not interrupted, there is the danger
of overload. Therefore, work with soft pressure in order to
avoid an excessive heating of the motor due to a too high
power input.
Hand Guard
Only run the Calender with the mounted protective hood.
B
Werkzeugwechsel
Attention!
Before the beginning of all works disconnect the plug from
the mains!
E
D
You can use the front roller (A) to set the
optimum pressure for the sanding rollers or
the structure depth when brushing wood.
To do this, open the knurled screw (8) and
bring the roller into the desired position.
Tighten the thumbscrew again.
A
C
Connect the vacuum hose to the nozzle of
the suction hood (C).
To mount the insert tool (grinding
roller, brush ...) loosen the wing
screw (D) and open the cover (E).
19