Worx WG324E.X Notice Originale page 14

1
1
1/3
When the log is supported on both ends, as
illustrated in Figure 4, cut 1/3 the diameter from the
top (overbuck) (1). Then make the finished cut by
underbucking (2) the lower 2/3 to meet the first cut.
1
1
1/3
1
1/3
14
1
When bucking on a slope always stand on the uphill
1/3
side of the log, as illustrated in Figure 5. When
"cutting through", to maintain complete control
release the cutting pressure near the end of the
cut without relaxing your grip on the pruning saw
handles. Don't let the chain contact the ground.
After completing the cut, wait for the saw chain to
stop before you move the pruning saw. Always stop
the motor before moving from tree to tree.
Cordless Pruning Saw
2
1/3
2/3
2
Figure 3
2/3
2
2
2/3
1/3
2/3
2
2/3
Figure 4
2
2/3
Figure 5
SYMBOLS
To reduce the risk of injury, user
must read instruction manual
Wear ear protection
Wear eye protection
Wear dust mask
Wear head protection
Beware of pruning saw kickback and
avoid contact with bar tip
Do not expose to rain
Wear protective gloves
Wear protective footwear
Warning of danger from overhead
electric-power lines
Do not burn
Batteries may enter water cycle if
disposed improperly, which can
be hazardous for ecosystem. Do
not dispose of waste batteries as
unsorted municipal waste.
EN