AEG FSE83807P Notice D'utilisation page 10

10 www.aeg.com
For any other questions regarding your
dishwasher please refer to the service
book provided with your appliance.
6. BASIC SETTINGS
You can configure the appliance by
changing basic settings according to
your needs.
Settings
Water hardness
Rinse aid level
End sound
Auto door open
Key tones
Latest prog. selec-
tion
Display on floor
Brightness
Language
Reset settings
PNC number
1) For more details, refer to the information provided in this chapter.
6.1 The water softener
The water softener removes minerals
from the water supply, which would have
a negative effect on the washing results
and on the appliance.
Values
From level 1 to level
10 (default: 5)
From level 0 to level
6 (default: 4)
ON
OFF (default)
ON (default)
OFF
ON (default)
OFF
ON
OFF (default)
ON (default)
OFF
From level 0 to level
9
List of languages
(default: English)
YES
NO
Number
Description
Adjust the level of the water softener accord-
ing to the water hardness in your area.
Adjust the level of the rinse aid according to
the necessary dosage.
Activate or deactivate the acoustic signal for
the end of a programme.
Activate or deactivate AirDry.
Activate or deactivate the sound of the but-
tons when pressed.
Enable or disable the automatic selection of
the most recently used programme and op-
1)
tions.
Activate or deactivate TimeBeam.
Adjust the brightness of the display.
Set the preferred language.
Reset the appliance to the factory settings.
Check the PNC number of your appliance.
The higher the content of these minerals,
the harder your water is. Water hardness
is measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water
in your area. It is important to set the
1)
1)
1)
1)
1)
1)