Philips SmoothCare GC3569 Mode D'emploi page 15

Problem
Water droplets
drip onto the
fabric during
ironing.
Water drips from
the Soleplate
after the iron has
cooled down or
has been stored.
Flakes and
impurities
come out of the
soleplate during
ironing.
When set to the
max position, the
steam control
jumps back.
Possible cause
You have not closed
the cap of the filling
opening properly.
You have put an
additive in the water
tank.
The set temperature
is too low for steam
ironing.
You have used
the steam
boostfunction at a
temperature setting
below 3.
You have put the
iron in horizontal
position with water
still left in the water
tank.
Hard water forms
flakes inside the
soleplate.
You have not
retained the steam
control in the
maximum position.
Solution
Press the cap until you hear
a click.
Rinse the water tank and do
not put any additive in the
water tank.
Set a temperature of 2 or
higher.
Set the temperature dial to a
setting between 3 and
MAX.
Empty the water tank.
Use the Calc-Clean function
one or more times (see
If you want to generate the
maximum steam rate, you
have to continuously hold the
steam control in the maximum
position. Please note, in other
steam control positions it is
not necessary to continuously
hold the steam control.
).
15