Philips SmoothCare GC3569 Mode D'emploi page 14

Problem
EN The iron is
plugged in, but the
soleplate is cold.
The iron does not
produce any
steam.
The iron does not
produce a
steam boost.
14
Possible cause
There is a
connection
problem.
The temperature
dial is set to MIN.
There is not enough
water in the water
tank.
The steam control
is set to position
(see ).
The iron is not hot
enough and/or the
drip-stop function
has been activated.
You have used the
steam boost function
too often within a
very short period.
The iron is not hot
enough.
There is not enough
water in the water
tank.
Solution
Check the mains cord, the
plug and the wall socket.
Set the temperature dial to
the required position.
Fill the water tank (see
Move the steam control to a
position somewhere between
the black zone (see
Set an ironing temperature
that is suitable for steam
ironing (2 to MAX). Put the
iron on its heel and wait until
the temperature light has
gone out before you start
ironing.
Continue ironing in horizontal
position and wait a while
before you use the steam
boost function again.
Set an ironing temperature
at which the steam boost
function can be used ( 3 to
MAX). Put the iron on its heel
and wait until the temperature
light has gone out before you
use the steam boost function.
Fill the water tank (see
).
).
).