Mixer Controls - Numark HDMIX Guide D'utilisation

MIXER CONTROLS

The HDMIX sports a powerful DJ mixer which can be used to mix audio from the internal hard drive, USB
storage devices, as well as additional input devices, such as CD players, turntables and microphones
connected to the inputs on the rear panel.
1. MICROPHONE CHANNEL – This channel features the following microphone controls, which affect the
Mic 1 input signal. Please note that the microphone signal is not routed to the crossfader and will be
sent directly to the master mix.
MIC – Mutes and unmutes the microphone signal. When muted (LED is off), the microphone
signal will not be routed to the master mix.
TREBLE – Adjusts the high (treble) frequencies of the microphone signal ± 10dB.
BASS – Adjusts the low (bass) frequencies of the microphone signal ± 10dB.
GAIN – Adjusts the microphone channel's pre-fader gain level ± 10dB.
CUE – Sends the microphone signal to the Headphone channel for auditioning.
2. CHANNEL 1 – This is an auxillary channel for connecting an additional microphone, turntable or line-
level device. Please note that this channel is not routed to the crossfader and will be sent directly to the
master mix. This channel features the following controls:
LINE / MIC 2 – Selects the input source to be routed to this mixer channel. Select LINE if you
would like to route an external input source, such as a CD player or turntable, connected to the
Channel 1 inputs on the rear panel. (If using a phono-level turntable, plese make sure that the
Channel 1 LINE / PHONO switch is set to PHONO). Select MIC 2 if you would like to route the
MIC 2 signal to this channel.
TRIM – Adjusts the channel's pre-fader gain level ± 10dB.
TREBLE – Adjusts the high (treble) frequencies of the channel ± 10dB.
MID – Adjusts the mid-range frequencies of the channel ± 10dB.
BASS – Adjusts the low (bass) frequencies of the channel ± 10dB.
VOLUME FADER – Adjusts channel volume.
CUE – Sends the Channel 1 signal to the Headphone channel for cueing.
12