Worx D-Tail WX647 Notice Originale page 12

Dust collection box
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to the
accessory packaging for further details. Store personnel
can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction
book carefully.
INTENDED USE
The machine is intended for dry sanding of wood,
plastic, filler and coated surfaces.The sander is not to be
used for plastering.
12
ASSEMBLY AND OPERATION
ACTION
ASSEMBLY
* Fitting the Sanding Paper
Using The Dust Adapter
Attaching the Dust Box
CAUTION: To prevent the
possibility of sanding dust or
foreign body being thrown into your
face or eyes, never attempt to use
your sander without the dust box
properly installed.
/ 1pc
Emptying the Dust Box
-For more efficient operation, empty
dusts box every 5-10mins.
OPERATION
On/Off Switch
Flush Sanding Facility
* Installing The Finger Pad
* Removing The Finger Pad
* Attach Sanding Sheets And
Pads
Sanding With Finger Pad
*
FIGURE
WORK HINTS FOR YOUR PALM SANDER
See Fig. A
If your power tool becomes too hot, run no load for 2-3
See Fig. B1, B2
minutes to cool the motor.
Always ensure the work-piece is firmly held or clamped to
prevent movement.
Any movement of the material may affect the quality of
the sanding finish.
See Fig. C
Start your sander before sanding and turn off only after
stopping sanding. For best results sand wood in the
direction of the grit.
Do not start sanding without sandpaper fitted.
WARNING: Failure to unplug the sander could
result in accidental starting causing possible
serious personal injury.
See Fig. D1,
D2, D3
See Fig. E
See Fig. F
See Fig. G1, G2
See Fig. H1, H2
See Fig. I
See Fig. J