Installation - Atag KD8178BD Instructions D'utilisation Et De Montage

4.3.1 To change the hinges
Fig. 3 (5,6,7,8) forwards using a flat-blade
u Lift off the covers
screwdriver.
u Loosen the top and bottom screws
ance body, without removing them.
u Pull the doors outwards and detach them.
Fig. 3 (9) to the opposite side and
u Transfer the screws
screw them in a little.
Fig. 3 (10) and change over the hinges
u Undo the screws
diagonally.
The screws Fig. 3 (10) are self-tapping: use a cordless screw-
driver.
u Screw the hinges firmly into place with 4 Nm.
Fig. 3 (12) in the now unused fastening holes.
u Place plugs
u Attach the doors to the pre-fitted screws
tighten the screws firmly with 4 Nm.
WARNING
Risk of injury due to the door dropping out!
If the fastening parts are not screwed into place firmly enough,
the door may drop out. This may lead to severe injuries. What
is more, the door may not close and therefore the appliance
may fail to cool properly.
u Screw the hinges firmly into place (with 4 Nm).
u Check all of the screws and retighten if necessary.

4.4 Installation

All the mounting components accompany the appliance.
Make sure the following tools are on hand:
Cordless screwdriver Torx®15, 20, 25
q
Screwdriver
q
Fig. 3
Spanner 13, Spirit level
q
The intermediate base and side wall of the kitchen unit have to
be at right angles to one another. Align the kitchen unit using a
Fig. 3 (9) on the appli-
spirit level and angle. If necessary, use shims.
The appliance can also be installed in an ordinary kitchen
cabinet. In this case detach the fittings of the unit door and
recess. They are no longer needed as the unit door is fitted to
the appliance door.
Note
u Before assembling the door of the unit, make sure that the
admissable weight of the unit door is not exceeded.
u Otherwise damage to the hinges and resultant malfunction
cannot be ruled out.
Fig. 3 (9) and
Refrigerator compartment door
Freezer compartment door
Check installation dimensions:
A
1772 mm - 1778 mm
Putting into operation
Max. weight of unit door
14 kg
12 kg
B C
1769.5 mm 695 mm
Fig. 4
31