Publicité
Les langues disponibles
Les langues disponibles
addiTional safeTy insTRucTions foR
youR scRewdRiVeR
1. Battery leakage may occur under extreme usage
or temperature conditions. If battery fluid comes
into contact with skin, wash with soap and water
and rinse with lemon juice and vinegar. If the
fluid comes into contact with the eyes, flush with
water for several minutes and contact a doctor
immediately.
2. Never burn batteries, they can explode in a fire.
3. Do not charge a leaking battery.
4. Use of an attachment and charger not
recommended or sold by the screwdriver
manufacturer may result in a risk of fire, electric
shock, or injury to persons.
5. Before screwing into a wall, in case of doubt check
with a metal-/voltage detector that you are not
breaking into an electricity, gas or water supply
lines.
6. Before you lay down the Screwdriver, make sure
that all moving parts have come to a stop.
7 . Avoid frequent stalling when screwing or drilling,
as this could damage the batteries.
8. Only connect the charging device to an AC supply.
9. Charge Screwdriver battery only with the
appropriate charging device.
10. The charging device and the Screwdriver must be
protected from moisture!
11. Do not use the charging device outdoors.
12. Do not store or use the tool and battery pack in
All manuals and user guides at all-guides.com
13. Always charge the battery pack between
14. Do not short out the contacts of battery or charger.
15. Respect the polarity "+/-" when charging.
16. hold power tool by insulated gripping
addiTional safeTy insTRucTions foR
youR chaRGeR
1. Before using the tool, read the instruction book
2. Charger is for indoor use only. Do not expose to
3. Do not charge non-rechargeable batteries.
4. If the supply cord is damaged, it must be replaced
locations where the temperature may reach or
exceed 39ºC. (Such as outside sheds or metal
building in summer).
temperatures 2ºC to 35ºC. Ideal charging
temperature is 18ºC to 29ºC.
surfaces, when performing an operation
where the fastener may contact hidden
wiring. Fasteners contacting a "live" wire may
make exposed metal parts of the power tool "live"
and could give the operator an electric shock.
carefully.
rain or water.
by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
7 7
Publicité
