Publicité
Les langues disponibles
Les langues disponibles
18
Setup and Quick Reference Guide
Great user manuals database on
127,&( 7R KHOS DYRLG SRVVLEOH GDPDJH WR WKH V\VWHP ERDUG ZDLW VHF
RQGV DIWHU WXUQLQJ RII WKH V\VWHP EHIRUH UHPRYLQJ D FRPSRQHQW IURP WKH
V\VWHP ERDUG RU GLVFRQQHFWLQJ D SHULSKHUDO GHYLFH IURP WKH FRPSXWHU
1.
Turn off your computer and any peripherals.
2.
Ground yourself by touching an unpainted metal surface on the chassis, such as
the metal around the card-slot openings at the back of the computer, before
touching anything inside your computer.
While you work, periodically touch an unpainted metal surface on the computer
chassis to dissipate any static electricity that might harm internal components.
3.
Disconnect your computer and peripherals from their power sources. Also, dis-
connect any telephone or telecommunication lines from the computer.
Doing so reduces the potential for personal injury or shock.
In addition, take note of these safety guidelines when appropriate:
‡
To avoid shorting out your computer when disconnecting a network cable, first
unplug the cable from the network interface controller (NIC) on the back of your
computer, and then from the network jack on the wall. When reconnecting a
network cable to your computer, first plug the cable into the network jack, and
then into the NIC.
‡
When you disconnect a cable, pull on its connector or on its strain-relief loop, not
on the cable itself. Some cables have a connector with locking tabs; if you are dis-
connecting this type of cable, press in on the locking tabs before disconnecting
the cable. As you pull connectors apart, keep them evenly aligned to avoid bend-
ing any connector pins. Also, before you connect a cable, make sure both
connectors are correctly oriented and aligned.
‡
Handle components and cards with care. Don't touch the components or con-
tacts on a card. Hold a card by its edges or by its metal mounting bracket. Hold a
component such as a microprocessor chip by its edges, not by its pins.
&$87,21 7KHUH LV D GDQJHU RI D QHZ EDWWHU\ H[SORGLQJ LI LW LV LQFRUUHFWO\
LQVWDOOHG 5HSODFH WKH EDWWHU\ RQO\ ZLWK WKH VDPH RU HTXLYDOHQW W\SH UHFRP
PHQGHG E\ WKH PDQXIDFWXUHU 'LVFDUG XVHG EDWWHULHV DFFRUGLQJ WR WKH
PDQXIDFWXUHU·V LQVWUXFWLRQV
3URWHFWLQJ $JDLQVW (OHFWURVWDWLF 'LVFKDUJH
Static electricity can harm delicate components inside your computer. To prevent
static
damage, discharge static electricity from your body before you touch any of your com-
puter's electronic components, such as the microprocessor. You can do so by
touching an unpainted metal surface on the computer chassis.
As you continue to work inside the computer, periodically touch an unpainted metal
surface to remove any static charge your body may have accumulated.
UserManuals.info
Publicité
