Siemens SITRANS LR 300 Notice De Mise En Service Simplifiée page 7

Local Programming
The hand programmer is used for local programming sequences. Hold the programmer close
to the unit (within 15cm [6"]), and point it directly at the bottom of the display to activate the
programming options
.
display
max. 150 mm (6")
hand
programmer
PROGRAM Mode:
The PROGRAM key toggles between RUN and PROGRAM mode.
The EDIT icon appears when you key in a new value: it remains visible until you press the
ENTER key and the new value is accepted.
Switching from RUN to PROGRAM mode:
Press to activate PROGRAM mode: the number fields go blank.
Accessing a parameter: scroll to the parameter number, or follow these steps:
1. Press to display the Parameter Number field.
2. Press again to open the Parameter Number
field. The field goes blank and the EDIT icon
appears
3. Key in the desired parameter number:
Example:
number and value appear.
Note:
Values shown are for demonstration purposes only.
Changing a parameter value:
1. Key in the new value. (The new value and the EDIT icon
2. Press to set the value. The EDIT icon disappears.
Resetting an individual parameter to Factory Setting
1. Scroll to the parameter or key in its address.
2. Press
.
3. The value field goes blank and the EDIT icon
4. Press . The value returns to factory default and the EDIT icon disappears.
7ML19985QA82
All manuals and user guides at all-guides.com
Key
Clear value
Toggle between Units and % on parameter value
Toggle between PROGRAM and RUN mode
Update echo quality parameters
Parameter scroll-up
Parameter scroll-down
Toggle fields
Enter the displayed value
. The new parameter
SITRANS LR 300 – QUICK START MANUAL
Programming Mode
appear.)
appears.
parameter value
parameter
number
edit icon
Page EN-5