dirna Bergstrom Bycool Green Série Instructions De Montage page 23

COMPACT 3.0
Position the interior air distribution panel on the
10
front studs with (1) M6 wide-flanged washer
and (1) M6 nut on each stud. Tighten the nuts
until the foam air duct comes up against the
unit's upper foam.
IMPORTANT: The rubber ducting must
being run into the upper rubber of the unit
to avoid air leaks.
10
EPDM
Gasket
Cabin roof
Upholstey
Tighten the nut in point 9a until it comes up
11
against the top part of the interior air distribution
panel.
11
EPDM
Gasket
Cabin roof
Upholstey
Unit base
Nut M6
Stud M6
Unit base
Nut M6 (9a)
Nut M6
Stud M6
Air conditioning for vehicles
Rubber ductings
Rubber ductings
23
EN
Foam
Interior air distribution
panel
Foam
Interior air distribution
panel