Uline H-7630 Instructions D'assemblage page 4

BOTTOM SHELF DIVIDER ASSEMBLY
1. Four bottom shelf dividers (8) are included with
packing station. To attach, slide shelf dividers
in-between full depth bottom shelf and 4" high
storage shelf and line them up with two pre-drilled
holes in each shelf. Fasten each divider with four M6
Phillips head bolts and four M6 flange nuts using a
Phillips screwdriver and 10 mm wrench.
(See Figure 10)
Figure 10
PAGE 4 OF 27
All manuals and user guides at all-guides.com
ASSEMBLY CONTINUED
UPRIGHT ASSEMBLY
1.
Pre-drilled
Holes
2. Repeat with other upright.
Position upright (9) on back corner of tabletop.
Mounting plate should be positioned directly over
the previously drilled holes. Fasten four M6 x 70 hex
bolts and flat washers through uprights, tabletop
and legs using 10 mm wrench. Secure with four M6
flange nuts on underside of table. (See Figure 11)
Figure 11
Upright
M6 x 70 mm
Bolt
Washer
Flange
Nut
Leg
Mounting
Plate
Upright
0621 IH-7630