Uline H-7590 Instructions D'installation

H-7590, H-8956
ZIPPERED OFFICE PANEL
TOOL NEEDED
Allen Wrench
(Included)
Panel x 1
1. Align steel foot with holes on underside of panel and
attach using two M6 x 20 mm screws. Fully tighten
with Allen wrench. Insert leveling foot to underside of
opposite end of panel and tighten. (See Figure 1)
NOTE: If connecting multiple panels, steel feet
do not need to be attached to interior panels.
Leveling feet can be used for both ends of
interior panels in place of steel feet.
Figure 1
Steel Foot
M6 x 20 mm
Screw
PAGE 1 OF 6
1-800-295-5510
uline.com
PARTS
Steel Foot x 1
ASSEMBLY
Leveling Foot
Allen Wrench
Pour le français, consulter les pages 5-6.
M6 x 20 mm Screw x 2
2. Place two panels together. Using one of the zippers
on the end of panel, insert zipper teeth into slider
and pull down to connect the panels. Repeat
as necessary to create longer runs. (See Figure 2)
NOTE: Ends of each panel have two zippers.
Both zippers do not need to be connected for
secure connection.
Figure 2
Para Español, vea páginas 3-4.
Leveling Foot x 2
1120 IH-7590