Uline H-7058 Mode D'emploi

H-7058
CONFERENCE TABLE
TOOLS NEEDED
Phillips
Screwdriver (Optional)
A
Camlock Pin x 18
F
Screw x 27
M4 x 16 mm
NOTE: Assemble on a smooth, non-marring
surface to avoid scratching the table.
• Check that all parts are included.
IMPORTANT: The arrow on the camlock (B) must
point toward the camlock pin (A) for proper
alignment. Turn camlock (B) clockwise until it
locks with pin (A).
IMPORTANT: Function of Cam
Make sure the arrow is pointing upwards
before inserting into the panel's hole.
1. Insert two camlocks (B) into holes on modesty panel
(3). Insert two camlock pins (A) and two dowels (C) in
outside leg (1). Fit outside leg (1) and modesty panel
(3) together and turn each camlock (B) clockwise
until it locks. Cover each camlock (B) with a camlock
cap (I). (See Figure 1)
PAGE 1 OF 9
1-800-295-5510
uline.com
Three Person Assembly
Drill
Required
B
Camlock x 18
G
Flat Bracket x 2
1/4 Right Turn
for Locking
PARTS
C D
Dowel x 16 Floor Glide x 6
H I
Deep Camlock Camlock Cap x 13
Cap x 5
ASSEMBLY
2. Repeat to attach the second outside leg and
modesty panel together.
3. Use four camlock pins (A), four camlocks (B) and four
dowels (C) to attach center leg (2) between the two
pieces assembled in Steps 1 and 2. (See Figure 1)
A
3
B
1
Para Español, vea páginas 4-6.
Pour le français, consulter les pages 7-9.
E
L-Bracket x 4
F
Screw x 18
M5 x 19 mm
1
C
3
I
3
2
1
Figure 1
0421 IH-7058