Publicité
Les langues disponibles
Les langues disponibles
TOP ASSEMBLY
1. To attach tabletop (10) onto frame assembly, place
tabletop on a smooth, non-marring surface with top
side facing down.
2. Rotate assembled frame upside down and line up
two pre-drilled holes on back corners of table top.
Do not insert screws into these two holes and the two
holes in front of them at this time. (See Figure 5)
Figure 5
Do Not
Insert Screws
Do Not
Insert Screws
Pre-drilled
Holes
3. Using all other hole locations in frame as a template,
drill 3/4" deep pilot holes into tabletop using a 3/16"
drill bit. Using 14 (16 for 72" table) wood screws and
a drill with a Phillips head drill bit, attach frame to
underside of tabletop in these new pilot holes.
(See Figure 6)
Figure 6
Wood
Screw
NOTE: Additional pre-drilled holes in tabletop
are used for a different product and will not
align with this frame. You must pre-drill your
own pilot holes.
NOTE: Wood screws for front and back of frame
are optional but provide more support.
PAGE 3 OF 27
All manuals and user guides at all-guides.com
ASSEMBLY CONTINUED
Pre-drilled
Holes
Front
Tabletop
Wood
Screw
Front
Tabletop
4. Using a 1/4" drill bit, drill four holes all the way
through tabletop in hole locations shown in Figure 7.
They should line up with holes in back of leg.
(See Figure 7)
NOTE: These will be used to attach uprights later.
Back
Figure 7
5. Carefully set table upright and recheck all screws
for tightness.
6. Place two storage shelf support brackets (5) onto
inside of legs with lip side facing down and inside
frame. Fasten each support bracket to legs with two
M10 x 65 hex bolts and two M10 nuts using a 17 mm
wrench. (See Figure 8)
Figure 8
M10 x 65 Bolt
and M10 Nut
7.
Slide 4" high storage shelf (4) onto lip of storage shelf
support brackets. Line up two holes located on side
of shelf with two holes in support brackets. Fasten
shelf to support brackets with four M6 x 15 hex bolts
and four M6 flange nuts using a 10 mm wrench.
(See Figure 9)
NOTE: If 4" shelf is difficult to slide in, loosen bolts.
Figure 9
4" High
Storage Shelf
8. Recheck and tighten all bolts.
Storage Shelf
Support Bracket
Top Not Shown
M6 x 15 Hex
Bolt and M6
Flange Nut
Top Not
Shown
0621 IH-7630
Publicité
