Uline H-7630 Instructions D'assemblage page 2

LEGS AND FRAME ASSEMBLY
NOTE: Table tops add 1⁄ – 1⁄" depending on
top purchased.
1. Flip legs (1) upside down. Place adjustable feet
(2) into legs and slide to desired height. Fasten
adjustable feet to legs with two M10 x 65 hex bolts
and two M10 nuts per adjustable foot using a 17 mm
wrench. (See Figure 1)
Figure 1
Adjustable
M10 x 65
Hex Bolt
Leg
2. Turn legs upright and spread apart to accommodate
full depth bottom shelf. Place full depth bottom shelf (6)
across leg braces. (See Figure 2)
Figure 2
Leg
Brace
Full Depth
Bottom Shelf
PAGE 2 OF 27
All manuals and user guides at all-guides.com
Feet
M10
Nut
Leg
Leg
Brace
ASSEMBLY
3. While bottom shelf is sitting on leg braces, slide two
bottom shelf support bars (7) underneath shelf and line
them up with outer holes in leg brace and shelf. Fasten
support bars to shelf and leg brace with four M8 x 40
hex bolts per support bar using a 13 mm wrench. Fasten
center of leg brace and shelf together with four M8 x 40
hex bolts and M8 nuts using a 13 mm wrench. Do not
tighten fully. (See Figure 3)
Figure 3
M8 x 40
Hex Bolt
4. Position frame support bars (3) so that the larger
holes are facing down. Line up with legs. Fasten
support bars to legs with four M8 x 65 hex bolts per
leg using a 13 mm wrench. (See Figure 4)
Figure 4
Bottom Shelf
Support Bars
M8 x 40
Hex Bolt
Frame Support
Bars
M8 x 65
Hex Bolts
0621 IH-7630