AGV RP60 Mode D'emploi page 9

1.1) Cheek pad removal/installation
1.2) Crown pad removal/installation
1
2
All manuals and user guides at all-guides.com
In order to remove the cheek pads, pull
them in the direction of the arrow as
shown in the figure.
To refit the cheek-pads fasten the press
studs. Check that the cheek pads are
perfectly secured to the helmet.
To remove the crown pad, release the 2
press studs at the front (1) the 2 at the
back of the helmet (2) and slide it out of
the helmet.
N.B. Extract the crown pad ONLY after
releasing all the press studs to avoid
damaging them and prevent damage
to the fabric parts.
To refit the crown pad, insert it inside the
helmet and fasten the 2 press studs at the
back and the 2 at the front into place.
9