Télécharger Imprimer la page

Panasonic WV-NW474S Mode D'emploi page 13

Publicité

Les langues disponibles

Les langues disponibles

● Video Output Connection
Connect the video output cable to the monitor or other
system device with the procured coaxial cable. The
maximum extensible length is shown in the table.
Type of
RG-59/U
coaxial cable
(3C-2V)
Recommended
(m)
250
maximum
(ft)
825
cable length
● Control Connector
Connect the respective peripherals to supply and
receive control signals. Use the supplied 5-pin cable
adapter. For electrical ratings, refer to SPECIFICA-
TIONS.
Pin#
Wire color
Function
1
Black
Alarm in
2
Gray
Alarm out
3
Pink
AUX out
4
Red
Day/night in Optical sensor
5
Green
GND
● Network Port Connection
Connect the network port to a PC or a network via a
hub with a 10BASE-T/100BASETX cable. Use the sup-
plied adapter (RJ-45, female-female) if necessary.
Note: For network system connections, refer to ■
Network Connection Types.
All manuals and user guides at all-guides.com
RG-6/U
RG-11/U
RG-15/U
(5C-2V)
(7C-2V)
(10C-2V)
500
600
800
1650
1 980
2 640
Example of
peripherals
Door switch
Buzzer
Lighting lamp
Signal ground
■ Image Adjustment
You can manually adjust the pan/tilt/azimuth angles,
focus, and zoom while observing the connected moni-
tor.
Notes:
• Do not hold the camera by the lens unit when
adjusting panning, tilting, or azimuth.
• The video output to the BNC will be interrupted while
an LCD monitor is connected to the monitor output
jack.
1. Connect an LCD monitor to the video jack.
2. Pan/tilt/azimuth adjustment
• Loosen the two screws locking the pan and tilt
tables.
• Pan and tilt the table to aim the camera at what you
need to watch.
• Turn the azimuth adjuster to obtain a level image.
• Tighten the two screws after adjustment.
Monitor
output jack
Pan lock screw
Panning table
Tilting lock screw
-13-
Variable angles
plus or minus 75°
(max.)
Azimuth adjuster

Publicité

loading