Publicité
After checking that all the controls on the panel
are in position "0" or at rest, connect the battery
connector to the machine connector.
• Close the battery compartment (lowering the
recovery tank) making sure not to crush any wires.
6.3
SETTINGS THROUGH THE
CONTROL PANEL
When switching on the machine using the key
switch (Photo M-1), press simultaneously the
BRUSH key (Photo M-5) + SUCTION key (Photo
M-4) on the control panel (Photo M).
When the display (Photo M-9) shows "TARA-
TURA???" (CALIBRATION???), also press the
SPEED REDUCTION key (Photo M-3) without
leaving the other keys.
When the message "TARATURA" (CALIBRATION)
is shown, release the keys previously pressed.
It is now possible to scroll through the settable
parameters pressing the BRUSH key (Photo M-5)
and the SUCTION key (Photo M-4):
- TIPO LOGO
(LOGO TYPE)
- TIPO BATTERIA
(BATTERY TYPE)
- CONTRASTO
(DISPLAY CONTRAST)
- LINGUA
(LANGUAGE)
- RIT. TASTI
(KEYS DELAY)
To select and change the desired parameter,
press the SPEED REDUCTION key (Photo M-3).
With the BRUSH key (Photo M-5) and the SUC-
TION key (Photo M-4) it is possible to increase
or decrease the set value. To confirm the new
value, press the SPEED REDUCTION key (Photo
M-3).
To exit the calibration select EXIT, and press the
SPEED REDUCTION key (Photo M-3).
MEANING OF SETTABLE PARAMETERS:
LOGO TYPE
Range: CTM, FASA, LAVOR
BATTERY TYPE
Range: Pb Acid / Gel
CONTRAST
Contrast value for the display.
LANGUAGE
Language that is displayed. In this version are
available: ITALIAN, FRENCH, ENGLISH, GERMAN,
SPANISH.
KEYS DELAY
Delay in hundredths of second between the accep-
tance of consecutive pressures of the keys. Establi-
shed to limit communication problems.
6.4
MACHINE PREPARATION
All manuals and user guides at all-guides.com
• Before starting to work, wear non-slip shoes,
gloves and any other personal protection device
indicated by the supplier of the detergent used or
considered necessary based on the operating en-
vironment.
☞ Do the following before starting to work. Refer
to the relative sections for a detailed description of
these steps:
Check the battery charge level and charge, if nec-
essary.
Mount the brushes or scraper disks (with the abra-
sive disks) that are suitable for the surface and
work involved.
Mount the squeegee, check that it is solidly at-
tached and connected to the suction hose and that
the drying straps are not too worn.
Make sure that the recovery tank is empty. If not,
empty it completely.
Check and completely close the detergent solution
release control.
Fill the detergent solution tank with a mix of clean
water and non-foaming detergent in an adequate
concentration through the rear hole. Leave 7 cm
between the mouth of the plug and the level of
the liquid.
☞ To avoid risks, become familiar with the machine
movements, carrying out test runs on a large sur-
face without obstacles.
To obtain the best results in terms of cleaning and
equipment service life, you should do the following
simple but important operations:
- Identify the work area, moving all possible obsta-
cles out of the way; if the surface is very extensive,
work in contiguous and parallel rectangular areas.
- Choose a straight work trajectory and begin work-
ing from the farthest area to avoid passing over
areas that have already been cleaned.
7. OPERATING INFORMATION
7.1
BATTERY CHARGING
Prepare and check the battery charge according
to the instructions provided in the specific section.
Detach the battery connector (the one with the
handle) from the machine power connector and
connect it to the battery charger connector.
• Do not connect the battery charger to the scrub-
ber-drier's main wiring connector.
Hold the connectors with the hands; do not pull
them using the cables.
If the machine is equipped with Pb-Acid batteries,
charge only in a well-ventilated area, lift the top
tank and open the battery plugs.
• Follow the steps indicated in the battery manu-
facturer's operating and safety manual (see the
battery maintenance section).
If the machine is equipped with gel batteries
(maintenance free), follow the instructions indi-
cated here below.
If the machine is used regularly:
Always keep the batteries connected to the battery
36
Publicité
