Black & Decker KD1250 Traduction Des Instructions Initiales page 9

Hammer drilling
• For hammer drilling in masonry and
concrete, set the operating mode
selector (4) to the
drilling mode selector (3) to the
position. When hammering, the tool
should not bounce and run smoothly. If
necessary, increase the speed.
Hammering
• For hammering with spindle lock, and for
light chiselling and chipping, set the
operating mode selector (4) to the
position and the drilling mode selector
(3) to the position.
• When changing from hammer drilling to
chiselling, turn the chisel to the desired
position. If resistance is felt during mode
change, slightly turn the chisel to engage
the spindle lock.
Switching on and o
• Select the required speed by turning the
speed selector dial (2).
• To switch the tool on, press the on/off
switch (1).
• To switch the tool off, release the on/off
switch.
Brush monitor (fig. E)
Your tool has a built in system that monitors
the health of the brushes.
• Green brush monitor indicator (17). The
brushes are in good condition.
• Red brush monitor indicator (18). The
brushes are warn and need replacing,
return your tool to an authorised
BLACK+DECKER Service Centre in order
to to have the brushes replaced.
Accessories
The performance of your tool depends on
the accessory used. BLACK+DECKER and
Piranha accessories are engineered to high
quality standards and designed to enhance
the performance of your tool. By using
these accessories you will get the very best
from your tool.
All manuals and user guides at all-guides.com
position and the
(Original instructions)
Maintenance
Your BLACK+DECKER corded/cordless
appliance/tool has been designed to operate
over a long period of time with a minimum
of maintenance. Continuous satisfactory
operation depends upon proper tool care
and regular cleaning.
Warning! Before performing any
maintenance on corded/cordless power
tools:
• Switch off and unplug the appliance/tool.
• Regularly clean the ventilation slots in
your appliance/tool/charger using a soft
brush or dry cloth.
• Regularly clean the motor housing using
a damp cloth. Do not use any abrasive or
solvent-based cleaner.
• Regularly open the chuck and tap it to
remove any dust from the interior (when
fitted).
Technical data
Input voltage
Power input
No-load speed
Impact rate
Impact energy per stroke
according to EPTA-
Procedure 05/2009
Weight
Max. drilling capacity
Concrete
Steel
Wood
Level of sound pressure according to EN 60745:
Sound pressure (L
pA
Sound power (L ) 104 dB(A), uncertainty (K) 3 dB(A)
WA
Vibration total values (triax vector sum) according to EN 60745:
Hammer drilling into concrete (a
Chiselling (a ) 13.6 m/s
h, Cheq
ENGLISH
KD1250 (Type 1)
V 230
AC
W 1250
min -1 0-850
min -1 0-4100
j
kg
mm
mm
mm
) 93 dB(A), uncertainty (K) 3 dB(A)
) 14.2 m/s 2 , uncertainty (K) 1.5 m/s
h, HD
2 , uncertainty (K) 1.5 m/s
3.2
5.4
32
13
40
2
2
9