Black & Decker KD1250 Traduction Des Instructions Initiales page 8

ENGLISH
Features
This tool includes some or all of the
following features.
1. On/O switch
2. Speed selector dial
3. Drilling mode selector
4. Operating mode selector
5. Tool holder
6. Side handle
7. Depth stop
8. Grease cap
Assembly
Warning! Before assembly, make sure that
the tool is switched o and unplugged.
Fitting the side handle (fig. A)
• Turn the grip counterclockwise until you
can slide the side handle (6) onto the
front of the tool as shown.
• Rotate the side handle into the desired
position.
• Tighten the side handle by turning the
grip clockwise.
Fitting and setting the depth stop (fig. A)
• Slacken the knob (9).
• Insert the depth stop (7) into the
mounting hole as shown.
• Set the depth stop (7) to the desired
position. The maximum drilling depth is
equal to the distance between the tip of
the drill bit and the front end of the
depth stop.
• Tighten the knob (9).
Fitting an accessory (fig. B - D)
• Clean and grease the shank (10) of the
accessory.
• Pull back the sleeve (11) and insert the
shank into the tool holder (5).
8
All manuals and user guides at all-guides.com
(Original instructions)
• Push the accessory down and turn it
slightly until it fits into the slots.
• Pull on the accessory to check if it is
properly locked. The hammering function
requires the accessory to be able to move
axially several centimetres when locked in
the tool holder.
• To remove the accessory, pull back the
sleeve (11) and pull out the accessory.
Keyed chuck (fig. D)
• Open the chuck by turning the sleeve (12)
anti-clockwise.
• Insert the bit shaft (13) into the chuck.
• Insert the chuck key (14) into each hole
(15) in the side of the chuck and turn
clockwise until tight.
Use
Warning! Let the tool work at its own pace.
Do not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
Warning! Do not apply chisels when the tool
is in the drilling mode.
Selecting the operating mode (fig. F)
The tool can be used in three operating
modes.
• To operate the drilling mode selector (3),
rotate it towards the required position, as
indicated by the symbols.
• To operate the operating mode selector
(4), push the unlock button (16) and
rotate the selector towards the required
position, as indicated by the symbols.
Drilling
• For drilling in steel, wood and plastics,
and for screwdriving set the operating
mode selector (4) to the
the drilling mode selector (3) to the
position.
position and