DeWalt D51430 Mode D'emploi page 22

E N G L I S H
• Increase the air pressure to the normal operating
level.
• Use the tool in the normal manner.
Hot weather operation
The tool should operate normally. Avoid the heat of
direct sunlight to avoid damage to the bumpers,
o-rings, and other rubber parts.
Actuating the tool (fig. A)
The tool can be operated using one of two modes.
The trigger installed on the tool determines the
mode of actuation.
Sequential action mode
The sequential action mode is used for intermittent
fastening when very careful and accurate placement
is desired.
• Fit the grey trigger as described above.
• Release the trigger lock (2).
• Push the contact trip (4) against the work surface.
• Pull the trigger (1) to actuate the tool.
Each trigger pull with the contact trip pushed
against the work surface will drive one fastener.
Bump action mode
The bump action mode is used for rapid fastening
on flat, stationary surfaces.
• Fit the black trigger as described above.
• Release the trigger lock (2).
• To drive a single fastener: Operate the tool as
described for sequential action.
• To drive several fasteners: Pull the trigger (1) first,
and then push the contact trip (4) repeatedly
against the work surface.
Do not keep the trigger depressed when
the tool is not in use. Keep the trigger
lock engaged to prevent accidental
actuation when the tool is not in use.
Clearing a jammed fastener (fig. E)
If a fastener becomes jammed in the nosepiece,
follow these instructions to remove the fastener:
• Disconnect the airline from the tool.
• Engage the trigger lock (2).
• Remove all fasteners from the magazine.
• Flip up the front latch (13) and move the bracket (14)
out of the way so that barrel (15) can be opened.
22
All manuals and user guides at all-guides.com
• Remove the bent fastener, using pliers if necessary.
• If the driving blade is in the down position, push
• Close the barrel (15) and put the bracket (14)
• Press the front latch (13) into the locked position.
• Feed the fasteners into the nose piece as
Optional accessories
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
over a long period of time with a minimum of
maintenance. Continuous satisfactory operation
depends on proper tool care and regular cleaning.
The following maintenance operations must be
performed every day.
Cleaning
• Clean the magazine and the nosepiece using
• Clean the front end of the contact trip using fuel
Draining
• Drain all condensation from the air compressor
Lubrication
• Insert 5 - 7 drops pneumatic tool oil into the air
Checking
• Ensure that all fasteners on the tool are tight and
• Tighten loose fasteners using the appropriate tool.
the driving blade upward using a screwdriver.
back in position.
described under „Loading the tool".
If fasteners become jammed in the
nosepiece frequently, have the tool
serviced by an authorised D
service centre.
WALT tool has been designed to operate
E
compressed air.
oil or diesel fuel.
tanks and hoses.
fitting on the end cap of the tool.
undamaged.
WALT
E